Dennis Goodson hand makes very cool parts, but always in very small quantities. And when they are gone, they are gone for a very long time. Like this sought after ribbed cast aluminum cover for all Fairbanks Morse bodied magnetos, like the Joe Hunt and Morris brands. Lowbrow Customs just got a new batch and you better rush if you want one. Highly polished and sealed inside, it is provided with a quality cork gasket, four stainless screws for installing the cover, and a new set of terminals for the ends of your plug wires. Installation instructions included. $135.00 + shipping.
Goodson Aluminum Magneto Cover
Published by April 28th, 2010 in Builders, Customs, Editorial and Electrical.8 Responses to “Goodson Aluminum Magneto Cover”
Comments are currently closed.
Wow! I had to go to the website to see if that price was a typo. Beautiful piece at one heck of a good price.
nice.
Got one of these from Dennis in 06 for the Hoodlum bobber we built that Cyril featured in this blog and it’s the coolest magneto cover out there ! We’re constantly getting the question thrown at us ” Where’d ya get that ! ”
They fit fantastic and work even better !
..It is nice to see parts like these ,that reflect good ole American craftsmanship and quality ,with a realistic price tag…..gotta love magnetos….
wow, and that price I am in for two. I can not believe it. I want one just to have it sit on the shelf.
Another alu magneto cover for the ones do not like the center rib produced by chopperlab.it. I saw it in Verona fair on a couple of bikes and bought one for 95€
http://img39.imageshack.us/img39/167/mg0766i.jpg
yepp, it’s that one:
ebay item No: 150554845468
found the same stuff produced by twinside-cycles.com without any logo. Goodson is not bad at all but i saw only for 240$ that is definitively too much for this little part.
Twinside cycles one is on ebay too for 139$ shipping included. They also make nice glass taillights